| Customization: | Available |
|---|---|
| Type: | Mechanic Equipment |
| Material: | Metal |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
|
Voltage
|
220V/50Hz±10% 110V/60Hz±10%
|
|
Power
|
60W
|
|
temperature
|
50ºC-130ºC/122° F-248° F
|
|
Dimension
|
12.5*18*5.5cm
|
One, matters needing attention:
1, in the use of wax, do not touch it, so as not to burn
2. Do not touch or plug or unplug the power cord with wet hands
3, the product is equipped with circuit board, to avoid impact and pressure, so as not to cause accidents
4. Do not block the ventilation position at the bottom of the product
5. Do not remove dust or water on the instrument when it is powered on (lest it cause click or fire)
6, when detected noise, smell and smoke, please immediately unplug the power supply
7, in lightning or thunder, please unplug the power supply
8, when the product failure, can not work normally, please immediately contact the dealer or manufacturer, do not decompose, repair and reassemble the instrument, otherwise the manufacturer can not be responsible for you
9, change the product to not waterproof type, only suitable for indoor use
10, do not arbitrarily change the product structure, power supply voltage should not exceed 10% of the rated value
11, it is strictly forbidden to empty burning without wax, no wax or water test, display temperature shall not exceed 50 degrees.
Second, electrical characteristics:
1.220V,50HZ+/-10% 2.110V,60HZ+/-10%
2, power: 60W.
3. Electrical insulation Class II
Third, operation instructions:
Plug in the power, turn on the switch, the red light on the upper left corner of the display window, the display window shows the current temperature. Make sure to choose °F or °C(Celsius) and then set the required temperature, the highest should not exceed 120°, after the temperature is set, the heater starts to work, when there is 4 to 5°C away from the set temperature, the red light will flash, when the set temperature is reached, the red light will automatically turn off, the wax tank is in the heat preservation state. When the temperature of the aluminum tank is 1°C lower than the set temperature, the heater automatically restores to work.
){kind=link}